Starter Ring Gear Could Become Separated from Clutch Assembly – 1999-2000 Ferrari 360 Modena & 360 Modena F1

December 6, 2024December 26, 2015 by oemdtc

SUMMARY:

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE STARTER RING GEAR, WHICH IS ATTACHED TO THE CLUTCH ASSEMBLY WITH THREE MOUNTING SCREWS, COULD BECOME SEPARATED FROM THE CLUTCH ASSEMBLY.

THIS POSSIBLE FAILURE COULD BE CAUSED BY (1) THE FRACTURE OF THE STARTER RING GEAR ITSELF AT THE MOUNTING HOLES DUE TO AN INCORRECT POSITIONING OF THE MOUNTING HOLES, OR (2) BY THE FAILURE OF THE MOUNTING SCREWS.

IF EITHER OF THESE CONDITIONS WOULD OCCUR, THE RESULT WOULD BE FRAGMENTS OF THE STARTER RING GEAR BEING THROWN FROM THE CLUTCH AREA.

CONSEQUENCE:

IF THESE FRAGMENTS CAME INTO CONTACT WITH THE VEHICLE’S TIRE, A PUNCTURE COULD OCCUR RESULTING IN LOSS OF VEHICLE CONTROL.

REMEDY:

DEALERS WILL (1) REPLACE THE STARTER RING GEAR MOUNTING SCREWS AND MEASURING THE STARTER RING GEAR MOUNTING HOLES.

THE MEASUREMENT OF THE STARTER RING GEAR WILL DETERMINE IF THE CORRECT POSITION OF THE MOUNTING HOLES EXISTS AND IF THE POSITION IS INCORRECT, THE STARTER RING GEAR WILL ALSO BE REPLACED; OR (2) REPLACE THE STARTER RING GEAR WITH A NEW RING GEAR HAVING THE CORRECTLY POSITIONED MOUNTING HOLES AND THE REPLACEMENT OF THE MOUNTING SCREWS.

NOTES:

OWNER NOTIFICATION BEGAN OCTOBER 31, 2000.

OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FERRARI AT 1-201-816-2651.